Troop composition with T8

We have earlier discussed troop composition with T5, T6 and T7.

Read step 1 in Troop composition 

Now we will add in T8 to the mix and at the same time look at the attack deployment composition.

Power Calculations

We have earlier calculated that Normal Troop types are the Type that has the least disadvantages compared to the other Troop Types.

When it comes to attack is thus a bit different, mostly due to the opposite calculation of the probabilities in an attack situation, so in a deployment setup vs a Base defense setup, we would slightly prefer Mercenary Troop Type.

The tables below shows a good example of a basic Deployment Setup consisting of T8 to T6.

If we again look at the ratios of power of Troop times power of Tier, we see that each Tier gives each Entity about an 25% increase weighted for power. Meaning that you need 50 T8 to get the same power balance as 100 T6.

Tactical Rapid Deployment

The second part of the presets below is the tactical advantage you have of mixing and matching troops when you deploy rapidly during a battle. In between these presets it is recommended to alternate a max queue Ghost Deployment. Ghost Deployment is a Deployment without the commander.

If you choose max queue you will automatically get the commander included. This is something you need to avoid, because it alter the defense ratio of the Base.

Below is a 3 preset setup for T8,T7,T6 Deployment. This is constructed with cost of training as an input variable in addition to the power ratio alone.

Preset 1 – Infantry

IMG_0362

Preset 2 – Tactical

IMG_0363

Preset 3 – Armored Vehicle

IMG_0364

 

Advertisements

Basic Battle Checklist Mobile Strike

Battle checklist

  • Check Commander gear
  • Check Insignia’s
  • Check Troops
  • Check Wall
  • Check Boosts
  • Check Rally partners
  • Check Phone / pad

This list expect that you have preset active for most tasks.

First time battle

  • Check Commander gear
  • Check Commander level
  • Check Skill Tree
  • Check VIP points
  • Check Insignia’s
  • Check Troops
  • Check Wall
  • Check Boosts
  • Check Piece shields
  • Check Teleport
  • Check Rally partners
  • Check Phone / pad
  • Check Time

Check commander gear

Is the commander wearing battle gear?
Are the correct mods installed, and are they installed on all items?
Are all the augments and the right augments installed?
Is the gear fully enhanced?
Is the gear level fully updated?

Check commander level

Have you updated the commander’s xp point to max?

Skill Tree

Is the Skill Tree preset set for battle?
Are you fighting at cp or just attack? – adjust accordingly

Check VIP points

Have you updated an added all your VIP points?

Check Troops

Are all troops trained?
Are all troop enhancements done?
Are all troop preset done?

Check wall

Is the wall full of traps?

Check boosts

Have you added all building boost if applicable?
Have you added all time limited boosts?
Have you decided to use attack or defense boost?
Are you fighting at cp or just attack? – adjust accordingly

Check Piece shield

Have you new shields ready if you need to shield?

Check teleport

Have you enough teleports to go both ways?

Check Insignia’s

Have you the right preset Insignia’s?
Have you activated all Insignia’s?
Are you fighting at cp or just attack? – adjust accordingly

Check rally partners

Are the other players ready to assist you?
Are the other players ready?

Check phone/pad

Is your phone/ pad charged?
Is the cell reception good and stable?

Check time

Are you free the next 20 min?

 

 

 

Cheating the Skill Tree

Within the Battle Tactics research tree, there is a box called Commander Preset II. This research gives you the ability to preset the points in the commander’s Skill Tree.

This means that you can redistribute the points as you see fit, depending on the gear and task at hand.

While the most natural method of filling in the points is from the top, you are better off filling it from the bottom of the tree.

The way this is done is by filling each box from the top just enough to open the next one. When you have gotten as deep as you can, you start to fill the boxes in the tree backwards.

The reason why you want to do this, is because the biggest bonuses and boosts exist at the bottom thus increasing the effect of each point you have earned.

Please note that you might need to test this a few times in order to figure out the optimal filling pattern based on your exact number of points.